Introduction; Supported Devices; Installing The Prescribe Emulation Option - Lexmark MX6500e 6500e Technical Reference Manual

Introduction

Introduction
The PRESCRIBE emulation option for Lexmark laser printers is an extended version of the firmware that includes a
PRESCRIBE language processor. It enables the printer to be an effective replacement for Kyocera printers in select large
accounts where the PRESCRIBE printer language is used.
Since Kyocera does not offer a single standard version of PRESCRIBE across all of its products, the emulation compatibility
of this version is based on testing with customer application test files and an extensive set of engineering command-
level tests.
This technical reference manual describes the capabilities of the PRESCRIBE emulation option and highlights the key
limitations, which customers must consider in their certification testing.

Supported devices

• Lexmark C746x, C748x
•
Lexmark C792
•
Lexmark C925
•
Lexmark C950
• Lexmark X548
• Lexmark X746x, X748x
•
Lexmark X792
•
Lexmark X925
•
Lexmark X950, X952, X954
• Lexmark 6500e

Installing the PRESCRIBE emulation option

Note: Installing the option may restore your printer to factory default settings. Before installing, print a Menu
Settings page so that any non-default settings can be restored.
For more information on installing and uninstalling the PRESCRIBE emulation option, see the installation instructions
that came with the option, or the printer User's Guide.
After installing the option, set up the PRESCRIBE FRPO (Firmware RePrOgram) defaults to match the Kyocera default
setup on the applications. Many accounts use the Kyocera factory default settings and may not require further setup.
For more information on the FRPO settings supported by the PRESCRIBE emulation option, see "FRPO: Firmware
RePrOgram" on page 13.
To verify installation, print a Print Menus page from the printer control panel. Under the Printer Information section,
there should be an entry for the PRESCRIBE emulation option (example: "P-Scribe = P41F"). The second page that prints
is a PRESCRIBE emulation STAT page with the current FRPO permanent settings.
3