Errata - Intel D945PWM Specification

®
Intel Desktop Board D945PWM Specification Update

ERRATA

1. The placement of capacitors behind PCI Express* x1
connector slot 1 may prohibit some PCI Express x1 add
in cards from properly connecting to the motherboard
P :
Due to the design and placement of the audio circuitry on this motherboard, it was necessary to
ROBLEM
position capacitors in the keep-out zone behind PCI Express* x1 connector slot 1.
I :
Some PCI Express x1 add-in cards may not fully connect to PCI Express x1 connector slot 1,
MPLICATION
due to interference between capacitors in the keep-out zone and I/O connectors on the add-in card that are
located on the I/O bracket, in line with the edge fingers on the card.
W :
None
ORKAROUND
S : M
TATUS AY BE FIXED IN A LATER HARDWARE REVISION
2. Design for the rear-panel MIC bias circuitry will not
correctly amplify rear-panel microphone recording
P :
Due to the transistor design for the rear-panel microphone circuitry, there is no audible recording
ROBLEM
level.
I :
The rear-panel microphone will not record at correct volume levels
MPLICATION
W :
The front panel audio connector may be used as it is not affected by this issue and will
ORKAROUND
produce an amplified microphone recording.
.
S
: Fixed
TATUS
6
.
-