Wall Mounting The Speaker - Pioneer HTZ-BD91HW Owner's Manual

16 Connecting

Wall mounting the speaker

Orange (+)
Before mounting
y Remember that the speaker system is heavy and
that its weight could cause the screws to work
loose, or the wall material to fail to support it,
resulting in the speaker falling. Make sure that
the wall you intend to mount the speaker on is
strong enough to support them. Do not mount
2
on plywood or soft surface walls.
y Mounting screws are not supplied. Use screws
suitable for the wall material and support the
weight of the speaker.
> ,
Caution
y If you are unsure of the qualities and
strength of the wall, consult a professional
for advice.
y Pioneer is not responsible for any accidents
or damage that result from improper
installation.
1. Use a Phillips screwdriver to remove the two
screws holding the stands to the speaker.
2. Using the two screws removed in step 1, fasten
the wall mounting fixtures to the speaker.
Orange (+)
Red (+)
White (+)
Black (–)
Red (+)
White (+)
Black (–)
3. Affix the supplied wire stays to the top of the
unit as shown and collect the cable there.
Press until a "click" is
heard.
4. Mount on wall.
Wall
mounting
screws
(available
commercially)*
6 mm to 8 mm
* Wall mounting screws are not included. Purchase
appropriate screws taking into consideration the
type of wall and the weight of the speaker system.
Open two holes in the wall 818 mm apart.