How To Replace The Auger - Craftsman C950-52935-1 Owner's Manual

ADJUSTMENT/REPAIR
HOW TO REPLACE THE AUGER
1. Remove the belt cover. See "How To Remove The Belt
Cover".
2. Remove the drive belt. See "How To Replace The Drive
Belt".
3. Remove the auger pulley from the auger shaft
(threads are left hand; turn clockwise to remove). (See
Figure 14).
4. To keep the auger from rotating, set a 2"x4" piece of
wood on the center paddle to secure auger.
5. Remove the fasteners from the bearing assembly. Re-
move the bearing assembly from the auger housing.
6. Slide the auger out of the bearing assembly on the
right side of the snow thrower.
7. Tip the auger enough to allow the auger to slide out of
the auger housing.
8. To install auger, reverse the above steps.
Auger Housing
Bearing Assemlby
Auger Pulley
Figure 14
F-001155M 16