Service Recommendations - Craftsman C950-52935-1 Owner's Manual

SERVICE RECOMMENDATIONS
SERVICE RECOMMENDATIONS
FIRST BEFORE EVERY EVERY EVERY BEGINNING
2 EACH 5 10 25 EACH BEFORE
PROCEDURE
HOUR USE OFTEN HOURS HOURS HOURS SEASON STORAGE
o
W Lubricate Chute Control _ _/
Flange
B
L
O
W
E
R ,/
Check Drive Belt
E
N
G
I
N Fuel, Drain _/
E
The warranty on this snow blower does not cover items that
have been subjected to operator abuse or negligence. To re-
ceive full value from the warranty, operator must maintain
snow blower as instructed in this manual. The following Ser-
vice Recommendations is supplied to assist operator to
properly maintain snow blower. This is a check list only. Ad-
justment referred to will be found in Adjustments/Repairs
section of this manual.
LUBRICATION
Before Storage
1. Remove the top cover. See "How To Remove The Top
Cover".
2. Lubricate the chute control flange. Apply a clinging
type of grease such as Lubriplate.
AFTER EACH USE
1. Check for any loose or damaged parts.
2. Tighten any loose fasteners.
3. Check and maintain the auger.
4. After each use, remove all snow and slush off the snow
blower to prevent freezing of auger or controls.
5. Check controlsto make sure they are functioning proper-
ly.
6. If any parts are worn or damaged, replace immediately.
F-001155M 12
Chute Control
Figure 5