Craftsman 113.177630 Owner's Manual page 9

.SP6503 20 Gallon 4/8/03 9:29 AM P_9
Operation (continued)
Emptying the Drum
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
1.The vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the drum.
2. Another option is to remove the power
assembly.
3. Lay power assembly aside on a clean
area while emptying drum.
4. Dump the drum contents into the proper
waste disposal container.
WARNING: To reduce the risk of
back injury or falls, do not lift a vac
heavy with liquid or debris. Scoop or
drain enough contents out to make
the vac light enough to lift
comfortably.
Moving
the Vac
Should it become necessary to pick the
vac up to move it, the handle on the sides
of the dust drum are used to lift. To
maneuver the vac, the push/pull handle in
the rear of the unit should be used.
Blowing Feature
Your vac features a blowing port, It can
blow sawdust and other debris, Follow the
steps below to use your vac as a blower,
WARNING: Always wear safety
goggles complying with ANSI Z87.1
(or in Canada, CSA Z94.3_99) before
us ng as a b ower.
WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
1. Locate blowing port of your vac.
2. Insert the locking end of the "Pos-I-
Lock" hose into the blowing port of the
vac. The hose should snap into place.
To remove the hose from the vac, press
the release button in the hose assembly
and pull the hose out of the vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose, then place the car
nozzle on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.
Sears recommended accessories are
available at Sears retail stores. The Sears
Blower Nozzle Stock No. 9-16933 is
recommended for blowing debris.
Push/Pull Handle
\
Car Nozzle Wand (Optional)
(Optional)
9