Craftsman 113.177630 Owner's Manual page 11

.SP6503 20 Gallon 4/8/03 9:29 AM P_ ii
Maintenance (continued)
Wet Nozzle
with the pins fitting through the matching
To pick up liquids off a smooth surface,
use the 2-1/2" wet nozzle accessory
supplied with your wet/dry vac. To use this
nozzle, simply attach the nozzle to the end
of an extension wand.
Connect a second extension wand to the
first, and connect the 2-1/2" x 7' hose to
the extension wand.
Liquids may be picked up by dragging the
nozzle across the surface. The squeegee
will dry the surface as you vacuum.
Replacement rubber for the squeegee
nozzle may be obtained through Sears
Parts. If the rubber becomes worn, it may
be flipped over for use on the opposite
side or replaced. (Replacement service
part #822256). To reverse or replace the
squeegee:
1. Lay the wet nozzle on a flat surface with
the round inlet opening facing up and
the two latches close to you as shown.
holes in the squeegee. (Make sure the new
working edge is located farthest from you.)
2. Using both hands, lower the nozzle body
onto the insert and squeegee with the
round opening of the nozzle closest to you.
With fingers on the far side and thumbs
holding the latches of the removable
insert, flip the nozzle over so the latches
are on the top and the round inlet opening
is facing away from you. Make sure the
squeegee stays on the insert pins.
3. Press down with each thumb below the
latching tabs until you see and hear the
removable insert snap into the nozzle
body. Snap the latches over the locking
tabs into their original position.
2, Using both hands, position each thumb
on the removable insert, (below the
latches) and two fingers of each hand
on each latch, lift and disengage the two
latches from the tabs on the nozzle
body.
3, Gently pull the latches toward yourself
to remove the insert.
To reinstall the removable insert correctly,
follow these steps:
1. Place the removable insert on a flat
surface with the pins positioned upward
and the latches close to you as shown.
Place the rubber squeegee on the insert,
4. Inspect the pins of the insert to make
sure they fit through the holes of the
squeegee and fit into the matching slots
in the nozzle body.
NOTE: If the pins are out of position, hold
the nozzle assembly with both hands and
gently twist in opposite directions. The insert
pins should snap into proper position.
The wet nozzle assembly is ready for wet
pickup use.
11