TO LEVEL MOWER HOUSING
AND ADJUSTMENTS
Adjust the mower whiletractor is parked on level ground or
driveway.
Make sure tires are properly inflated (See
"PRODUCT SPECIFICATIONS" on page 3 of this manual).
If tires are over or underinflated, you will not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT (See Figs. 17 and 18)
,
Raise mower to its highest position.
°
At the midpoint of both sides of mower, measure height
from bottom edge of mower to ground. Distance "A" on
both sides of mower should be the same or within 1/4"
of each other.
•
If adjustment is necessary, make adjustment on one
side of mower only.
•
To raise one side of mower, tighten lift link adjustment
nut on that side.
o
To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Each full turn of adjustment nut will change mower
height about 1/8".
•
Recheck measurements after adjusting.
BOTTOM EDGE
BOTTOM EDGE
OF MOWER TO
OF MOWER TO
GROUND LINE
FIG. 17
(_
SUSPENSION
LIFT LINK
ADJUSTMENT NUT
2O
FIG. 18
,,,,,,,,,,,,,,,,,,,
............................................
FRONT-TO-BACK ADJUSTMENT (See Figs. 19 and 20)
IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF
THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS
NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS
EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-
SIDE.
To obtain the best cutting results, the mower housing
should be adjusted so that the front is approximately 1/4" to
3/4" lower than the rear when the mower is in its highest
position.
Check adjustment on right side of tractor. Measure dis-
tance"D" directly in front and behind the mandrel at bottom
edge of mower housing as shown.
•
Before making any necessary adjustments, check that
both front links are equal in length. Both links should be
approximately 10-3/8".
•
If links are not equal in length, adjust one link to same
length as other link.
°
To lower front of mower loosen nut "E" on both front
links an equal number of turns.
•
When distance "D _ is 1/4" to 3/4" lower at front than
rear, tighten nuts "F" against trunnion on both front
links.
°
To raise front of mower, loosen nut"F" from trunnion on
both front links. Tighten nut "E" on both front links an
equal number of turns.
•
When distance "D" is 1/4" to 3/4" lower at front than
rear, tighten nut"F" against trunnion on both front links.
•
Recheck side-to-side adjustment.
MANDREL
FIG. 19
BOTHFRONT LINKS MUST BE EQUAL IN LENGTH
FRONT LINKS
TRUNNION
FIG. 20