Advertisement
fSTEP
(5):
_'
CC (4)
• Assemble (2)(CC)in
each of the leg assemblies (D & E).
Some adjustment may be necessary after workbench is in
desired location.
• Finger tighten.
?
?
J
STEP (6):
• Place the workbench in its upright position.
• Measure from the right leg 5".
• Attach the CRAFTSMAN
nameplate (F) on the front rail in this
location. Centering the nameplate horizontally on the rail.
/
/
desired position with 1/2
open end wrench as shown. ,,"
desired position. The weight
of the unit will keep it in
.....
place.
"_
\\
\\\\
f
• Periodically the surfaces should be cleaned with a mild
detergent and water.
• Periodically check the fasteners to be sure they have not
loosened. If they have, re-tighten.
• Grease and oil can be removed with most standard cleaning
fluids. For safety, use a nonflammable
cleaning fluid.
• Auto wax will preserve the unit's luster finish. Apply the wax as
to a car. The wax will also help protect the unit against
scratches.
Advertisement
