Craftsman 113.22560 Owner's Manual page 6

UB SANDER/GRINDER
UPPER
:::.: TRACKING SCREW IPPER GUARD
ARM \
i : : _ _!_ \ f_ /UPPER WHEEL
"'-^o,_W T _: _ _ _ \_ LOWER
_""_ :_ 4_"r:..__ h',_'lft .-.--TRACKING SCREW
TABLE LOCK NUT locks:table in place. Use a square or '
0,o, 0c,o,,o00,o,,,0 o,o a0 0 <o< ......
: : :[ [_//\ "._I ,,i /ARRAS VE BELT
TRACKING SCREWS are adjusted to track belt. :_ s_--.-_l
(REF .) UPPER I_L/'_E: SCREWS
N_ 2" /
_._ _" ,,_LE_._I Wtl P
REAR IDLER _ PLATEN
WITH PROVISION
FOR LOCKING
G
--,----,. _ _
ER WHEEL
BELT AND _ _ fJ
PULLEY GUARD
RUBBER
FEET
BASE
. _ __ •
BASIC SANDERIGRINDER: OPERATIONS
We recommend the following instructions for operating
your Sander/Grinder so :that you get the best results and to
minimize personal injury.
WARNING: FOR YOUR OWN SAFETY, ALWAYS
OBSERVE THE FOLLOWING SAFETY PRECAUTIONS.
1, Make sure Table Lock Nut is always tight.
2, Remove plug from power source outlet when adjusting
table, changing belts, or removing Or adjusting platen.
3, After turning switch ON, always allow the belt to come
up to full speed before sanding or grinding.
4. Make sure belt always tracks properly. Push the
w0rkpiece or cutting tool gently against the belt...
allowing the belt to cut without reducing the belt speed
appreciably or stalling the motor.
5. Keep your hands clear of the belt.
6. Replace belts when they become loaded (glazed) or
frayed.
SANDING WOOD OR PLASTICS
Move the workpiece across the belt.