Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Craftsman Manuals
  4. Blower
  5. 358.794940
  6. Instruction manual

Craftsman 358.794940 Instruction Manual

25cc/1.5 cu.in. 2-cycle 200 mph/400 cfm gasoline powered blower/vac
Hide thumbs

Advertisement

Quick Links

Download this manual
Enlarged version
Instruction
Manual
I CRAFTSMAN°I
25cc/1.5
cu.in. 2-Cycle
200 MPH/400
CFM
GASOLINE
POWERED
BLOWER/VAC
Model
No.
358.794940
•
Safety
•
Assembly
•
Operation
•
Maintenance
•
Parts List
•
Espar_ol
WARNING:
Read and follow all Safety Rules and Operating
Instructions before first use of this product.
For answers to your questions
about this product:
Call 7 am-7
pm, Mon.-Sat.,
or 10 am-7
pm, Sun.
1-800-235-5878
(Hours listed are Central Time)
Sears, Roebuck
and Co., Hoffman
Estates,
IL 60179 U.S.A.
530165839-01
1/19/05

Advertisement

loading

Related Manuals for Craftsman 358.794940

Summary of Contents for Craftsman 358.794940

  • Page 1 Instruction Manual I CRAFTSMAN°I 25cc/1.5 cu.in. 2-Cycle 200 MPH/400 GASOLINE POWERED BLOWER/VAC Model 358.794940 • Safety • Assembly • Operation • Maintenance • Parts List • Espar_ol WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product.
  • Page 2 Operation Spanish Maintenance Parts and Ordering Back Storage FULL TWO YEAR WARRANTY ON CRAFTSMAN® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions in the instruction manual, Sears will repair, free of charge, any defects in material or workmanship.
  • Page 3 • Do not set unit on any surface ex- • Use only recommended Craftsman cept a clean, hard area while engine replacement parts; use of any other is running. Debris such as gravel, parts may void your warranty sand, dust, grass, etc.
  • Page 4 • Empty fuel tank before storing the Users who operate power tools on a unit. Use up fuel left in carburetor continual and regular basis must moni- starting engine and letting it run until tor closely their physical condition the condition of this tool. it stops.
  • Page 5 Secure the tube by turning the lower knob clockwise. Outlet 3. To remove the tube, turn the knob tctu ea counterclockwise to loosen the tube; remove the tube. inlet Cover VACUUM ASSEMBLY VACUUM BAG ASSEMBLY 1. Open tile zipper on the vacuum Gently tilt the handle of the screw- bag and insert the elbow tube.
  • Page 6 Extend your left arm toward the rear of the vacuum bag. Adjust shoulder strap until the vac- uum bag/shoulder strap seam lies between your thumb and index finger. 5. Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly.
  • Page 7 2-cycle air-cooled engine oil. • In dusty conditions, slightly dampen We recommend Craftsman brand syn- surfaces or use a mister attachment thetic oil. Mix gasoline and oil at a ratio when water is available. of 40:1. A 40:1 ratio is obtained by mix- •...
  • Page 8 Craftsman brand oil is already blended STARTING A COLD ENGINE with fuel stabilizer. See the STORAGE 1.
  • Page 9 STARTING A FLOODED ENGINE 1. Move the throttle lever to the Flooded engines can be started by plac- position. ing the choke lever in the RUN position. Pull the starter handle sharply until Move throttle lever to the fast position the engine starts, but no more than 4r_ ;...
  • Page 10 CLEAN AIR FILTER REPLACE FUEL FILTER To replace fuel filter, drain unit by run- ning it dry of fuel, then remove fuel cap/retainer assembly from tank. Pull filter from tank and remove it from the fuel line. Install new fuel filter on fuel Air Filter line;...
  • Page 11 Run lated area where fuel vapors cannot engine at least 5 minutes after adding stabilizer. reach sparks or open flames from water heaters, electric motors or Craftsman 40:1,2-cycle engine oil (air cooled) is already blended with fuel switches, furnaces, etc.

  • Page 12: Troubleshooting

    TROUBLESHOOTING TABLE (continued) CAUSE TROUBLE REMEDY 1. Air filter dirty. Engh_e will not 1. Clean or replace air filter. 2. Fuel not reaching 2. Check for dirty fueI filter; replace. accelerate, carburetor. Check for kinked or split fuel line; lacks power, or dies under a repair or replace.
  • Page 13 WHAT IS NOT COVERED: All failures off-road engine is purchased. LENGTH OF COVERAGE: This warranty shall be caused by abuse, neglect, or improper maintenance are not covered. ADD-ON for a period of two years from the initial OR MODIFIED PARTS: The use of date of purchase.