Craftsman 358.794342 Instruction Manual
Craftsman 358.794342 Instruction Manual

Craftsman 358.794342 Instruction Manual

25cc/1.5 cu.in. 2-cycle 205 mph/410 cfm gasoline powered blower/vac

Advertisement

Available languages

Available languages

Instruction
Manual
I CRAFTSMAN°I
25cc/1.5
cu.in. 2-Cycle
205 MPH/410
CFM
GASOLINE
POWERED
BLOWER/VAC
Model
No.
358.794342
Safety
i ssem ,,
Operation
Maintenance
_j_
_
PartsList
Espar__
WARNING:
Read and follow all Safety Rules and Operating
Instructions before first use of this product.
For answers to your questions
about this product:
Call 7 am-7
pm, Mon.-Sat.,
or 10 am-7
pm, Sun.
1-800-235-5878
(Hours listed are Central Time)
Sears, Roebuck
and Co., Hoffman
Estates,
IL 60179 U.S.A.
530165754
9/7/05

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 358.794342 and is the answer not in the manual?

Questions and answers

Summary of Contents for Craftsman 358.794342

  • Page 1 Instruction Manual I CRAFTSMAN°I 25cc/1.5 cu.in. 2-Cycle 205 MPH/410 GASOLINE POWERED BLOWER/VAC Model 358.794342 • Safety Operation i ssem ,, Maintenance PartsList Espar__ WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions...
  • Page 2 Operation Spanish Maintenance Parts and Ordering Back Storage FULL TWO YEAR WARRANTY ON CRAFTSMAN ® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions in the instruction manual, Sears will repair, free of charge, any defects in material or workmanship.
  • Page 3 • Do not set unit on any surface except • Use only recommended Craftsman ® a clean, hard area while engine is run- replacement parts; use of any other ning. Debris such as gravel, sand, parts may void your warranty dust, grass, etc.
  • Page 4 • Empty fuel tank before storing the who operate power tools on a continual unit. Use up fuel left in carburetor and regular basis must monitor closely starting engine and letting it run until their physical condition and the condition of this tool.
  • Page 5 VACUUM ASSEMBLY Gently tilt the handle of the screw- driver toward the back of the unit to VACUUM BAG ASSEMBLY release the latch while pulling up 1. Open tile zipper on the vacuum on the vacuum inlet cover with your bag and insert the elbow tube.
  • Page 6 Reinstallthe blowertube (see 5. Make sure air flows freely from the elbow tube into bag. If bag is kinked, BLOWER TUBE ASSEMBLY). the unit will not operate properly. SHOULDER STRAP ADJUSTMENT (for vacuum use only) 1. Hold the unit as shown with the muffler side facing away from your body and clothes.
  • Page 7 2-cycle air-cooled engine oil when water is available. We recommend Craftsman brand syn- • Conserve water by using power blow- thetic oil. Mix gasoline and oil at a ratio ers instead of hoses for many lawn of 40:1.
  • Page 8: Starting A Cold Engine

    Craftsman brand oil is already blended ing the unit or property, or causing seri- with fuel stabilizer. See the STORAGE ous injury to bystanders or the operator.
  • Page 9 8. Allow the unit to run for 30 more NOTE: If the engine has not started, seconds at RUN before moving the pull starter handle sharply for 5 more throttle lever to the _ position. pulls. If engine still does not run, it is If the engine has not started after 5 probably flooded.
  • Page 10 INSPECT AND CLEAN UNIT Replace with Champion CJ-6Y AND LABELS spark plug and tighten securely with a 3/4 inch socket wrench. • After each use, inspect complete unit Reinstall the spark plug boot. for loose or damaged parts. Clean REPLACE FUEL FILTER the unit using a damp cloth with a To replace fuel filter, drain unit by run-...
  • Page 11: Fuel System

    • Store unit and fuel in a well venti- engine at least 5 minutes after adding lated area where fuel vapors cannot stabilizer. reach sparks or open flames from Craftsman 40:1,2-cycle engine oil (air water heaters, electric motors or cooled) is already blended with fuel switches, furnaces, etc.
  • Page 12: Troubleshooting

    TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before perform- ing any of the recommended remedies below other than remedies that re- quire operation of the unit. CAUSE TROUBLE REMEDY 1. Engh_eflooded, Engine will not 1. See "Starting a Flooded Engine"...
  • Page 13: Warranty

    rials or workmanship of the engine uled only for regular inspection to the causes the failure of such an emission effect of "repair or replace as necessary" related part, the part will be repaired or shall be warranted for 2 years. Any war- replaced by Sears.
  • Page 14 Contratapa GARANTIA DE DOS AI_IOS COMPLETOS PARA EL PROPULSOR DE AIRE A GASOLINA DE LA MARCA CRAFTSMAN ® Durante dos (2) a_os a partir de la fecha de compra, siempre que se haga el mantenimiento, la lubricaci6n y los ajustes en este Propulsor de Aire a Gasolina...
  • Page 15 PIENSE ANTES DE PROCEDER • Alejese pot Io menos 3 metros (10 • Use siempre protecci6n para los ojos pies) del combustible y del lugar de al hacer uso, servicio o mantenimi- abastecimineto antes de poner el motor en marcha. ento del aparato.
  • Page 16: Aviso De Seguridad

    • Use exclusivamente los repuestos ida en perfecto estado de funcionamien- recomendados de la marca to, o que el motor est6 conetruido y Craftsman®; el use de cualquier otro equipado para la prevenci6n de incen- repuesto podr& invalidar la garantia dios y mantenido correctamente.
  • Page 17: Montaje

    la Iocalidad donde usted se encuentra, chispa, los tubos de propulsi6n y las bo- entre en contacto con el Servicio de quillas deber&n estar instalados en el Sears para obtener el equipo de re- aparato para estar en total cumplimiento puestos correspondiente.
  • Page 18 Introduzca el tubo en forma de codo en la salida de aire del Cerradura PIVOTE de la propulsi6n. AsegOrese de que la entrada moldura del tubo en forma de codo aire este alineada con la ranura de salida de aire del propulsi6n. Gire la perilla hacia la derecha para apretar el tube en forma de codo.
  • Page 19 4. Ajuste la correa de hombre hasta que la costura entre la bolsa de as- piraci6n y la correa quede entre el pulgar y el indice. 5. AsegQrese de que el aire circule libremente desde el tube en forma de code hasta la bolsa. Si la bolsa se encuentra torcide, el aparato no funcionar&...
  • Page 20 • Conserve agua usando el propulsor de 2 tiempos enfriados a aire. Recomendamos el aceite de sintetico en lugar de mangueras de agua para de la marca Craftsman. Mezcle la las tantas aplicaciones del c6sped y de jardinefia, incluyendo &teas como...
  • Page 21 Aspirador dep6sitos de goma en el combustible durante el almacenaje. El aceite de la marcha Craftsman viene ya mezclado con estabilizador de combustible. ADVERTENCIA: AI arrancar el la secci6n de ALMACENAJE para m&s motor, sostenga el aparato como se informaci6n.
  • Page 22 Palanca det Bot6n del PARA ARRANCAR CON EL MOTOR aceterador bombeador CALIENTI= AVI$O: Si el tanque de combustible est& vacio, agregue el combustible; luego, eiga el procedimiento PARA ARRANCAR CON MOTOR FRIO. No Ilene el tanque de combustible mientras el motor est&...
  • Page 23 RESPONSABILIDAD DEL USUARIO ADVERTENCIA: Desconecte la bujia antes de realizar mantenimiento, servicio, o ajustes. TAREA DE CUIDADO Y MANTENIMIENTO CUANDO HACER Antes de cada uso Verificar que no haya fijadores fiojos ni piezas sueltas Antes de cada uso Verificar que no haya piezas dafladas o gastadas Inspeccione y limpie el aparato y sus placas...
  • Page 24 VERIFIQUE LOS TORNILLOS Siempre limpie el filtro de aire despu6s ded cada 5 horas de uso. MONTAJE DEL SILENCIADOR Para prevenir daflos, aseg_rese anu- Limpieza del filtro del aire: 1. Limpie la cubierta y el &rea conti- almente de que los tornillos de mon- taje del silenciador se encuentren gua para evitar que caiga tierra en...
  • Page 25 Io menos 5 minutos des- tanques, motores o interruptores pu6s de haberle puesto el estabilizador. el6ctricos, calefactores centrales, El aceite de la marca Craftsman 40:1 etc. para motores a 2 tiempos (enfriados • Guarde el aparato con todos los pro- aire) ya viene mezclado...
  • Page 26 TABLA DIAGNOSTICA ADVERTENCIA: Siempre apague el aparato y desconecte la bujia antes de hacer cualquiera de las reparaciones recomendadas a continuaci6n no requieran que la unidad est6 en operaci6n. SlNTOMA CAUSA SOLUCION El motor no 1. El motor esta ahogado. 1.
  • Page 27 SUS DERECHOS Y OBLIGACIONES Onicamente a causa de la falta de reci- DE GARANTIA: La Agencia de Pro- bos o por el incumplimiento de su tecci6n Ambiental de los Estados Uni- parte en asegurarse que el mantenimi- dos, la Junta de Recursos Ambien- ento programado haya side de-...
  • Page 28 COMO ENTABLAR UNA RECLAMA- para efectos de "reparaci6n o reempla- zo si fuera necesario" deber_, garanti- CION: Si cuenta usted con alguna pre- zarse per un periodo de dos a_os. gunta relacionada con sus derechos y Cualquier pieza garantizada que este responsabilidades de garantia, usted...

Table of Contents