Advertisement
• Empty fuel tank before storing the
unit. Use up fuel left in carburetor
by
starting engine and letting it run until
it stops.
• Do not use any accessory or attach-
ment other than those recommended
by manufacturer
for use with your unit.
• Do not store the unit or fuel in a closed
area where fuel vapors can reach
sparks or an open flame from hot
water heaters, electric motors or
switches, furnaces, etc.
• Store in a dry area out of reach of
children.
SAFETY
NOTICE:
Exposure
to vibra-
tions through prolonged
use of gaso-
line powered hand tools could cause
blood vessel or nerve damage
in the
fingers, hands, and joints of people
prone to circulation
disorders or abnor-
mal swelling. Prolonged
use in cold
weather has been linked to blood ves-
sel damage
in otherwise
healthy
people. If symptoms
occur such as
numbness,
pain, loss of strength,
change in skin color or texture, or loss
of feeling in the fingers, hands, or
joints, discontinue
the use of this tool
and seek medical attention. An
antivibration
system does not guaran-
tee the avoidance
of these problems.
Users who operate power tools on a
continual and regular basis must moni-
tor closely their physical condition
and
the condition of this tool.
SPECIAL
NOTICE:
For users on U.S.
Forest Land and in some states, includ-
ing California (Public Resources Codes
4442 and 4443), Idaho, Maine, Minne-
sota, New Jersey, Oregon, and Wash-
ington: Certain internal combustion en-
gines operated on forest, brush, and/or
grass covered land in the above areas
are required to be equipped with a spark
arresting screen, maintained in effective
working order, or the engine must be
constructed, equipped, and maintained
for the prevention of fire. Check with
your state or local authorities for regula-
tions pertaining to these requirements.
Failure to follow these requirements
is a
violation of the law. This unit is not facto-
ry equipped with a spark arresting
screen; however, a spark arresting
screen is available as an optional part. If
a spark arresting screen is required in
your area, contact Sears Service for the
correct kit. The spark arresting screen,
blower tubes, and nozzles must be as-
sembled to unit to be in full compliance
with regulations.
CARTON
CONTENTS
Check carton contents
against the fol-
lowing list.
Model
358.794940
• Blower
• Blower tube
• Elbow tube
• Vacuum bag
• Upper vacuum
tube
• Lower vacuum
tube
• 2-Cycle engine oil
NOTE: It is normal for the fuel filter to
rattle in the empty fuel tank.
ASSEMBLY
_.WARNING:
Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum
in-
let door or attempting
to insert or re-
move the vacuum tubes. The rotating
blades can cause serious injury.
,_
WARNING:
If you receive
your
unit assembled,
repeat all steps to en-
sure your unit is properly assembled
and all fasteners
are secure.
•
A standard
screwdriver
is required
for assembly.
BLOWER
ASSEMBLY
BLOWER
TUBE ASSEMBLY
If you have already assembled
your
unit for use as a vacuum,
remove the
vacuum
tubes and collection
bag.
1. Align the rib on the blower tube
with the groove in the blower outlet;
slide the tube into place.
NOTE: Knob must be loose enough to
allow blower tube to be inserted in blow-
er outlet. Loosen knob by turning coun-
terclockwise.
17'_ _
Blower
Ootlet Blower
£,_'_-_,,_,'_ q_
./
Tube
_Groove _
_
Rib..........
-4-
Advertisement
