Download Print this page

Craftsman 358.794940 Instruction Manual page 6

25cc/1.5 cu.in. 2-cycle 200 mph/400 cfm gasoline powered blower/vac

Advertisement

3.
Remove the vacuum
bag.
4= Close the vacuum
inlet cover and
make sure it is latched closed.
5= Reinstallthe
blowertube
(see
BLOWER TUBE ASSEMBLY).
SHOULDER
STRAP ADJUSTMENT
(for vacuum
use only)
1. Hold the unit as shown with the
muffler side facing away from your
body and clothes.
2= Pass the shoulder strap over your
head and onto your right shoulder.
3.
Extend your left arm toward the
rear of the vacuum
bag.
4.
Adjust shoulder strap until the vac-
uum bag/shoulder
strap seam lies
between
your thumb and index
finger.
5. Make sure air flows freely from the
elbow tube into bag. If bag is kinked,
the unit will not operate properly.
KNOW
YOUR
BLOWER
READ THIS iNSTRUCTiON
MANUAL AND SAFETY
RULES BEFORE
OPERATING
YOUR
UNIT.
Compare
the illustrations
with
your
unit to familiarize
yourself
with the location
of the various
controls
and adjustments.
Save
this manual
for future
reference.
Upper
Lower
Vacuum
T_
Vacuum
Tube
Elbow Tube
Blower
Tube
Throttle
Lever
Primer
Button
Choke
Lever
Fuel Mix
Fill Cap
Starter
Rope
Rear
Handle
THROTTLE
LEVER
The THROTI-LE LEVER is used to select
the desired engine speed and to stop the
engine. Move the throttle lever to the
'{_ position for full speed operation.
Move the throttle lever to the _
posi-
tion for idle speed.
To stop the engine,
move the throttle lever to the STOP posi-
tion.
PRIMER
BUTTON
The PRIMER BUqq-ONremoves air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the starter
rope. Activate primer button by pressing
it and allowing it to return to its original
position.
-6-

Advertisement

loading