2.5
Connecting the Receiver to the Power Supply
Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.
As no mains switch is fitted to this unit, ensure the local power supply is switched
OFF before connecting the supply cord.
The receiver is not fitted with an on/off switch. Ensure that the socket-outlet is
installed near the equipment so that it is easily accessible. Failure to isolate the
equipment properly may cause a safety hazard.
Connect the receiver to the power supply as follows:
1. Ensure the power supply is isolated and switched off.
2. Ensure the correct fuse type and rating has been fitted to both the equipment
3. Connect the lead to the receiver input connector and then to the power supply.
4. Switch on the power supply.
Table 7
Power Supply
100-120 V AC / 220-240 V AC
Note:
EN/LZT 790 0008/1 R1A
2011-03-30
and the power cable.
Fuse Type and Rating
Refer to the Reference Guide for all power supply, fuse replacement, safety,
EMC information and operating conditions
Warning!
Fuse Type and Rating
IEC/EN 60127-2 Sheet 5
Bussmann S505/Littelfuse 215
2 A 250 V T HBC
Installing the Equipment
11 (40)