Connecting The Receiver To The Power Supply; Table 5 Fuse Type And Rating - Ericsson RX8200 User Manual

Type of Connector
ASI/SD-SDI/HD-SDI
OUT 1 , 2 & 3
ASI INPUT
CONTROL 1 & 2
AC POWER
TECHNICAL EARTH
2.5

Connecting the Receiver to the Power Supply

Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.
As no mains switch is fitted to this unit, ensure the local power supply is switched
OFF before connecting the supply cord.
The receiver is not fitted with an on/off switch. Ensure that the socket-outlet is
installed near the equipment so that it is easily accessible. Failure to isolate the
equipment properly may cause a safety hazard.
Connect the receiver to the power supply as follows:
1. Ensure the power supply is isolated and switched off.
2. Ensure the correct fuse type and rating has been fitted to both the equipment
3. Connect the lead to the receiver input connector and then to the power supply.
4. Switch on the power supply.
Table 5
Power Supply
100-120 V AC / 220-240 V AC
Note:
EN/LZT 790 0009 R1A 2011-03-30
and the power cable.
Fuse Type and Rating
Refer to the Reference Guide for all power supply, fuse replacement, safety,
EMC information and operating conditions.
Description
75 Ω BNC connector for ASI or SDI (user selectable)
output feeds.
75 Ω BNC connector for ASI input feed.
8-way RJ-45 connectors for 10/100BaseT Ethernet
control and monitoring.
IEC100-120 V AC / 220-240 V AC power input.
Spade connector for unit technical earth.
Warning!
Fuse Type and Rating
IEC/EN 60127-2 Sheet 5
Bussmann S505/Littelfuse 215
2 A 250 V T HBC
Installing the Equipment
11 (44 )