Advertisement
CUSTOM
LINES
TRACTOR
Always observe safety rules when performing any mainte-
nance.
BRAKE
OPERATION
If tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted.
(See "TO ADJUST BRAKE" in the Service and Adjust-
ments section of this manual).
TIRES
o
Maintain proper air pressure in all tires (See "PROD-
UCT SPECIFICATIONS"
on page 3 of this manual).
o
Keep tires free of gasoline, oil, or insect control chemi-
cals which can harm rubber.
-
Avoid stumps, stones, deep ruts, sharp objects and
other hazards that may cause tire damage.
BLADE
CARE
For best results mower blades must be kept sharp.
Re-
place bent or damaged blades.
BLADE
REMOVAL
(See Fig. 15)
Raise mower to highest position to allow access to
blades.
-
Remove hex bolt, lock washerand flat washer securing
blade.
-
Insta_lt n ew or resharpened blade with trailing edge up
towards deck as shown.
o
Reassemble hex bolt, tock washer arid flat washer in
exact order as shown.
-
Tighten bolt securely (30-35 Ft. Lbs. torque).
iMPORTANT: BLADE BOLT tS GRADE8 HEATTREATED.
NOTE: Wedo not recommend sharpening blade- but if you
do, be sure the blade is balanced.
LOCK
TRAiLiNG
EDG5 UP
I
FIG. 15
TO SHARPEN
BLADE
(See Fig. t 6),
Care should be taken to keep the blade balanced.
An
unbalanced blade will cause excessive vibration and even-
tual damage to mower and engine.
,
The blade can be sharpened with a file or on a grinding
wheel. Do not attempt to sharpen while on the mower.
,
To check blade balance, you will need a 5/8" diameter
steel bolt, pin, or a cone balancer. (When using a cone
balancer, follow
the instructions supplied
with bal-
ancer).
-
Slide biade on to an unthreaded portion of the steel bolt
or pin and hold the bolt 6r pin para]iet with the groun&
If blade is bafanced, it should remain in a horizontal
position.
If either end of the blade moves downward,
sharpen the heavy end until the blade is balanced,
NOTE: Do not use a nail for balancing blade, The Jobes of
the center hole may appear to be centered, but are not.
CENTER HOLE
/
/
/
5/8" BOLT
OR PiN
BLADE
F1G. 16
BATTERY
Your tractor has a battery charging system which is suffF
cient for normal use. However, periodic charging of the
battery with an automotive charger will extend its life,
o
Keep battery and terminals clean.
o
Keep battery bolts tight.
-
Keep small Vent holes open,
•
Recharge at 6-10 amperes for I hour:
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause
the battery to "leak" power.
o
Remove terminal guard.
o
Disconnect
BLACK battery cable first
then RED
battery cable and remove battery from tractor.
•
Rinse the battery with plain water and dry.
o
Clean terminals and battery cable ends with wire brush
until bright.
Coat terminals with grease or petroleum jelly.
o
Reinstall battery (See "CONNECT BATTERY" in the
Assembly section of this manual),
18
Advertisement
