Advertisement
TO HELP kI_NTAIN
CONTROL:
•
Always supportyour workplece near the cut.
•
Support your _orkpieco sothe cut will be on your left.
•
Clamp ymJrimdq_ieea so it willnot move during the cut.
Place your _mckpiece with its good side down.
[_k_'e:The good _
is the side on which appearance is
important.
Before begirming a cut, draw a guideline along the desired
line of cut. Then place front edge of base on that part of
your workpiece that is sor_
supported. See Figure 13.
Never place your saw on that part of the workpiece
that will fall off _
Ihe cut is made. See Figure 15.
Hold your saw firmly with both hands.
See Figure 16+
Fig. 15
FLIGHT
Fig. 16
Depress the lock-off button and squeeze the switch trigger
to start your saw. Always let the blade reach full speed,
then guide your saw into the workpiese.
_k
WARNING:
The blade coming in contact with the
workpiece before it reaches full speed could cause
your saw to "kickback"
towards you resulting in
serious injury.
When making a cut use steady, even pressure.
Forcing
causes rough cuts, could shorten the life of your saw and
could cause "kickback."
REMEMBER:
When sawing _
work, the lower blade guard
does not cover the blade, e_posing it on the
underside of _
Keep your hands and fingers away
from cutting area. Any part of your body coming in
contact with the mo_
blade will resuR in serious
injury.
After you complete your cut release the trigger and allow
the blade to come to a complete stop. De not
your saw from wodlq_e_e _
the blade is moving.
A
CAUTION: _
_
your saw from the
workpiece, the blade is exposed on the underside of
your saw untilthe lower blade guard closes. Make
sure lower blade _
is closed before setting your
saw down on _
surface+
15
Advertisement
