Advertisement
•
When
making
a cut use steady,
even
pressure.
Never
force
cuts.
•
Do not cut warped or wet lumber.
•
Always hold your sow firmly with both hands and keep
your body in a balanced position so as to resist the
forces of kickback should it occur.
using your saw, always stay alert and exercise
cor_rol.
Do not r_
your saw from workpiece
while the blade is moving.
DEPTH OF CUT ADJUSTMENT
Always keep correct blade depth setting. The correct
blade depth setting for all cuts should not exceed 1/4 inch
below the material
to be cut. More blade depth will
increase the chance of kickback and cause the cut to be
rough. One blade tooth below the material to be cut wo_s
best for most efficient cutting action.
"rid ADJUST
BLADE DEPTH
•
Remove battery pack from saw.
WARNING:
Failure to remove battery pack from
saw could result in accidental
starting causing
possible serious personal injury.
•
Loosen depth adjustment knob. See Figure 12.
STARTING A CUT
Know the right way to use yOUr saw.
See F_gure 13.
Never use your saw as shown in figure 14.
Fig. 13
TORAISE
SAW"
TO
TIGHTEN
BASE
TO
ASSEMBLY
LOOSEN
DEPTH
TO
ADJUSTMENT
LO_
SAW
KNOB
Fig. 12
•
Hold base flat against the workpiece and raise or lo_er
saw until the required depth is reached.
•
Tighten depth adjustment
knob securely,
Fig. 14
Never place your hand on the m:wkpiece
behind your
sa_ mr, bile maldng a ced.
A
WARNING:
To rna_ sewing easier and safer,
always maintain proper controlof your saw. Loss of
controlof your saw could cause an accident resultir'_g
in possiblo serious injury.
14
Advertisement
