Advertisement
ASSEMBLY
(NSTRUCT(ONS
To assemble first side (side with two wheels):
m Remove wheels, hex bolts, and lock nuts from the bag.
m Place wheel in slot of the wheel support bracket and
insert hex bolt through both the bracket and the wheel.
[] Secure with the lock nut and tighten.
[] Place center support (without the slot) upside down on
a fiat surface. Align the wheel support brackets with the
hobs previously determined to fit the saw. Using the
small hex bolts and hex nuts from the hardware bag,
place hex bolts through the hobs of both the wheel
support bracket and the center support.
[] Tighten using hex nuts.
Note: Repeat above steps for other side.
To assemble remaining side (side with two leveling feet
and caster):
m Mount caster to the caster bracket using large hex
bolts. Secure using lock nuts.
m Attach leveling feet to lower support bracket using hex
nuts and washers as shown in figure 3. Leveling feet
must touch the floor when the caster is in the raised
position.
m Secure bracket to underside of center support using the
remaining large hex bolts and hex nuts.
m Place center support (with slot and attached caster)
upside down on a fiat surface. Align the lower support
brackets with the hobs previously determined to fit the
saw. Using the small hex bolts and hex nuts from the
hardware bag, place hex bolts through the hobs of
both the lower support bracket and the center support.
[] Tighten using hex nuts.
[] Turn assembly upright onto leveling feet.
[] (nsert release lever into slot. Using the large bolt,
washer, and lock nut, secure release lever. Tighten.
[] (f saw is mounted to a leg stand, remove the saw from
the leg stand before installing the mobile base.
[] Remove leveling feet from leg stand. Secure the mobile
base to the leg stand using the large hex bolt and large
hex nut.
[] Mount the saw and remove support brace from the leg
stand (the support above the release lever). Do not
discard the support brace and hardware. (n the event
the saw is ever removed from the mobile base the
support brace must be installed.
,_
WARN(NG:
Obtain help when lifting the saw to
place on the leg stand. Once the saw is mounted,
remove the support brace from the leg stand (the
support above the release lever). Failure to remove
the support brace, could result in injury.
TO RA(SE WHEEL:
Step down firmly on release lever.
TO LOWER
WHEEL:
Place foot under the release lever and lift up.
Note: Never use your hand to raise or lower the wheel.
CENTERSUPPORT
HEXBOLT
HEXHUT,
FLANGED_
HEXBOLT
_WHEEL
SUPPORTBRACKET
LOCK NUT
WHEEL
LARGE BOLT
J
LOCK HUT
WHEEL
Fig. 2
RELEASE
LEVER
WA_
NUT
@
@
SLOT
LOCKNUT
CASTER
BRACKET
LARGE
HEXBOLT_
WASHER
CASTER
HEXNUT
LEVEUNG FEET
TO
RA(SE
LARGE
HEX BOLT
&
Fig. 3
TO
Fig. 4
Advertisement
