Advertisement
_
WARNING:
Always wear safely goggles or safely
glasses with side shieldswhen operatingtools. Failure
to do so couldresult in objects being thrown intoyour
eyes. resulting in possibleserious injury.
_.
WARNING:
Do notallow familiaritywith your mini
driverto make you careless. Remember that a careless
fractionof a second is sufficientto inflictsevere injury.
CHARGING BATTERY PACK
The battery pack in this tool has been shipped in a low
charge condition to prevent possible problems.Therefore,
you shouldcharge it 8 to 10 hours prior to use.
Note: Battery pack will not reach full charge the first time it is
charged. Allowseveral cycles (drivingscrews followedby
recharging) for battery pack to become fullycharged.
TO CHARGE
•
Lock switch by slidingthe lock button forward.
See Figure 2.
SWITCH
LOC
_k
TO
LOCK
TO
YUNLOCK
Fig. 2
Remove battery pack from mini driver by depressing
tabs located on battery pack then pull on battery pack in
the direction of the arrow as shown in figure 3 to
remove.
TAB
•BA'n'ERY
PACK
TAB
Fig. 3
•
Charge battery pack onlywith the charger provided.
•
Make sure power supply Is normal household
voltage, 120 volts, 60 Hz, AC only.
•
Position battery pack so that the key on battery pack
aligns with the key slotin charger. See Figure 4.
,E, S LOT
UG.T
(t" 1 "I
.....
I _it
/_-_k'it
KEY
BATI'ERY
I II
/
,;cK
CHARGERs-
_
TABS
v
Fig. 4
•
Insert battery pack in charger and press down until tabs
snap into place.
•
Foldplugbladesoutthenconnectchargerto powersupply.
Note: Do not place charger in an area of extreme heat
or cold. It will work best at normal room temperature.
•
The green lightandred lightlocatedon frontofchargerwill
turnon. The greenlightindicates the chargeris connected
to powersupplyandwillremainon untildisoonnected. The
red lightindicates battery packischarging.
•
Allowbattery pack to charge 8 to 10 hours.
•
Disconnect charger from power supply.
•
Remove battery pack from charger by depressingtabs
on battery pack then pullto remove. Place battery pack
back in mini driver.
•
Fold plug blades in and storecharger.
•
After normal usage, a minimum of 8 to 10 hours of
charging time is required to be fully charged.
COLLET
The coUet on your mini driverhas been designed to accept
1/4 in. hex bits.
TO INSERT BIT
See Figure 5.
•
Lock switch by slidingthe lock button forward.
See Figure 2.
•
Remove frontcover from mini driver. See Figure 5.
FRONT
_
COVER
BIT
C0LLET
Fig. 5
•
Insert bit intocollet as far as possible.
•
When finished usingyour minidriver, remove bit from
collet and place frontcover back on mini driver.
Advertisement
