Install Seat - Craftsman 917.253540 Operator's Manual

INSTALL SEAT
1. Remove bolt and flat washer secur-
ing seat to cardboard packing and set
aside for assembly of seat to tractor.
Remove the cardboard packing and
discard,
2. Connect switch to seat.
3. Place seat on seat pan so all three (3)
bottom pads are positioned over large
slotted holes in pan.
4. Push down on seat to engage pads in
slots and pull seat towards rear of trac-
tor.
5. Raise seat and tighten bolt securely.
6. Remove tape and discard.
7. Lower seat into operating position and
sit on seat. Press clutch/brake pedal all
the way down. If operating position is
not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle
and pull up, slide seat to desired position
and release adjustment handle.
Slot Tape
NOTE: You may now roll your tractor off the
skid. Followthe instructions belowto remove
the tractor from the skid.
WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR OFF SKiD (See
Operation section for location and
function of controls)
1. Raise attachment lift lever to its highest
position.
.
.
Release parking brake by depressing
brake pedal.
Place freewheel control in disengaged
position to disengage transmission (See
"TO TRANSPORT" in the Operation sec-
tion of this manual).
4. Roll tractor forward off skid.
5. Remove banding holding the deflector
shield up against tractor.
Continue with the instructions that follow.
Flat
washer
Bolt
pan
Tab
/
Adjustment
handle
9