Maintenance; Change Oil - Briggs & Stratton Sno/Gard 170400 Series Operating And Maintenance Instructions Manual

Table of Contents

Advertisement

Maintenance
CAUTION:
TO PREVENT ACCIDENTAL
-
STARTING
when servicing the engirie or
equipment, always remove the wire from
r
the spark plug and
holding
insert In
tab.
Disconnect
negative wire from battery ter-
minal, if equipped with 12 volt startingsys-
tem.
_::::2-'
CHECK
OIL LEVEL
REGULARLY:
Check after each 5 hours of operalion or
daily. BE SURE OIL LEVEL
IS MAIN-
TAINED,
GENERAL
RECOMMENDATIONS
Occasionally
place a few drops of oil on governor
and throille linkage and choke. A slight filmof oiI on
these parts will afford additional protection
from
freezing and corrosion,
After using snow remora] equipment, conlinue to
run the engine for about 10 minutes in an area pro-
tected from snow, This will give the engine an oppor-
tunity to dry out any moislure which has collecled.
When equipment is not in operation, provide protec-
tion from direct exposure to freezing rain or snow.
CHANGE
OIL AS RECOMMENDED:
Change oil after first 5 hours of operation, Then, un-
der normal operating conditions, change oil after
every 50 hoursol operation or every season, which-
ever occurs first, Change oil aher every 25 hours of
operalion il the engine is operated under heavy
load. Remove oil drain plug and drain oil while en-
gine is warm, Replace drain plug, Remove oil till
plug or dipstick and refill with new oll of correct
grade, Replace oil fill plug or dipstick.
OIL FILL
PLUG
DRAIN
PLUG
SIDES
CHANGE OIL (Gear Reduction Ootion_:
Remove oil leve} plug and oil fill plug. Drain oil after
every 100 hours of operation or every season,
whichever occurs first. To refill, pour SAE 30 oil into
oil fill hole until it runs out ]eve] check hole. Replace
both plugs. Oil fill plug has a vent hole and must be
installed on lop of gear case cover.
OIL FILL
OIL LEVEL
OIL DRAIN
PLUG
GEAR REDUCTIONOIL FILL
I
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sno/gard 190400 series

Table of Contents