Convergence Adjustment - Samsung PCK6115R Service Manual

4-6 Convergence Adjustment

1. Warm up the TV for at least 30 minutes.
2. Input an NTSC Signal. (Use an antenna or AV source.)
Make sure that both deflection and convergence yokes are
properly adjusted so that the center of Green, Red, Blue pattern
NOTE
is aligned on the center of screen jig.
3. Enter the Convergence Mode by pressing the remote control keys in the following sequence:
If OSD is displayed as shown in figure below, press the
Then, redo step 3 to enter the Convergence Mode.
NOTE
After entering the Convergence Mode, Stand by for about five seconds before
doing the adjustments.
Samsung Electronics
Alignment and Adjustments
key to exit.
4-13