Table of Contents
Advertisement
B. Hardware Reference
B.1. Specifications
Parameter
Range
The adapter interfaces to the physical media through an FC-0 Media Interface (FC-PI compliant transceiver), and
Media Interface
then connects through a single optical fiber LC connector.
Low-profile MD2 form factor, 6.600 inches by 2.536 inches, and accommodates both the full-height and low-pro-
Physical
file bracket.
Dimensions
In a PCI/PCI-X, 66-MHz host:
•
3.2 watts (typical) @ +3.3 VDC
•
4.8 watts (typical) @ +5.0 VDC
•
8.0 watts (total typical)
Power
Requirements
In a PCI-X, 100/133-MHz host:
•
3.7 watts (typical) @ +3.3 VDC
•
5.2 watts (typical) @ +5.0 VDC
•
8.9 watts (total typical)
100 lf/min (minimum)
Airflow
41° to 113° F (5° to 45° C), Operating
Temperature
-40° to 158° F (-40° to 70° C), Storage
5% to 95% non-condensing, 23° C wet bulb
Humidity
B.2. Laser Safety Notice
This laser safety information contains certification and product information covering laser products known as optical
Gigabaud Link Modules (GLMs), Gigabit Interface Converters (GBICs), 1x9 and small form factor transceivers sold
as accessories to or incorporated in Emulex LightPulse host adapters. The GLM, GBIC, 1x9 and small form factor
transceiver are the primary cable connection mechanisms for any optical port on the host adapter and hub. This data is
not intended to be a replacement for any safety regulations and standards; relevant safety documents should always be
consulted if necessary. Contact Emulex Corporation with any questions or concerns about laser safety.
Certification and Classification
LP6000 and LP7000E PCI host adapters may contain a laser product known as an optical Gigabaud Link Module
(GLM). The optical GLM is attached to the host adapter using an 80-pin connector and extends through the mounting
bracket. In turn, the host adapter can be inserted into any host system's PCI slot.
The LH5000 hub may contain a laser product known as a Gigabit Interface Connector (GBIC). The GBIC provides
the physical connector to the optical cable. The GBIC can be inserted into any pluggable hub port.
The LP8000, LP850 and LP9000 PCI host adapter may contain a laser product known as a Gigabit Interface
Converter (GBIC) or an embedded 1x9 transceiver. The GBIC and or 1x9 transceiver provide the physical connection
to the optical cable, and its SC-style connector extends through the mounting bracket. In turn, the host adapter can be
inserted into any host system's PCI slot.
The LP9002, LP9002L, LP952L, LP9002S, LP9002DC, LP9002C, LP9402DC, LP9802, LP982, LP9802DC,
LP10000, LP10000DC, LP1050DC, LP1050 and NetWin 110 host adapters may contain a laser product known as a
small form factor transceiver. This transceiver provides the physical connection to the optical cable, and its LC-style
connector extends through the mounting bracket. In turn, the host adapter can be inserted into any host system's
appropriate PCI/PCI-X/cPCI/SBus expansion slot.
NetWin 110 HBA User's Guide
Page B-1
Advertisement
Table of Contents
