GE Monogram ZBD6605 Owner's Manual page 23

Questions?
Use this
prob#m
solT)eT"
PROBLEM POSSIBLE CAUSE WHAT TO DO
Suds in the tub (cont.)
Dishes and flatware
not clean
T()o
IS/HcN IJISSe
ageIst used
Water leaks through
door hmldle
hnproper rack loading
Filter or spray amss dirty
Inlet water temperature
is below 120°F
Air gap is clogged
Water pressure is
temporarily low
Opening door during
cycle with out pa using
machine first
For all other models:
• Pump out water by closing the door tmfil
it locks into place.
• Press the NORMAl, _;__SH button, then
press start.
• Wait ti)r one minute, then press and hold
down the START/CANCEl, button tot
three seconds. Repeat if necessary.
• Rein ove any spilled rinse aid.
• Reduce rinse aid setting.
• For soti water, rinse aid iSS}lV be tllSlsecessai'v;
• Make sure large dishware does not block
the detergent dispenser or the wash arm.
• _ssure silverware is not blocking spray ares.
• Clean filte_ and spray ;runs according to
instructions on page 90.
• Rms tap until water is hot, prior to starting
Chef's Washer cycle.
• Raise the water heater temperature to 120°E
• Depending on model, use X_;__TER TEMP
HIGH or X4?tTER TEMP SANI option if
suitable tot dish load.
• Clean the air gap.
• TllI'IS oIS }1 thtlcet. ]Is l_;IteI" COlSSiisg o/lt ISSOI'e
slowly than usual? If so, wait until pressure
is normal betore using yore" Chef's Washe_:
• Pa use the cycle before opening the door.
Follow inst_ uctions tot inten upting the
cycle tot yore" specific model.
23