Final Steps - Kenmore 24-Inch Wide/120-Volt LAUNDRY CENTER Owner's Manual And Installation Instructions

6#
REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and will increase your satisfaction
with your Kenmore laundry center.
[] Check electrical requirements•
Be sure you have correct electrical
supply and recommended grounding
method•
[] Check that you have:
• All the tools you started with.
• Removed all packaging materials.
• Installed all parts listed on
pages 5-9.
[] Check that the laundry center
is level.
[] Check that the water faucets
are turned on.
[] Ensure that laundry center is
positioned in its final location. Make
sure vent is not crushed or kinked.
FINAL STEPS
[] Plug the power supply cord into
the grounded outlet.
[-1Turn power supply on.
[7 Wipe the interior of the dryer drum
thoroughly with a damp cloth to
remove any dust.
[] Remove the blue protective film on
the console and any tape remaining
on laundry center•
[] Take a few minutes and read the
Operating Instructions (pages 29-38)
to fully understand your new laundry
center•
[]
[]
Start the washer and allow it to
complete the HEAVY DUTY Cyclf
Start the dryer and allow it to corr
a full heat cycle (not the AIR DR
Cycle). After five minutes, open
door. You should feel heat insic
dryer. If you do not feel heat, s
Troubleshooting information o
pages 53-54.
NOTE: You may notice a bur
odor. This smell is common
the heating element is first F
The smell will go away.
28