Kenmore 24-Inch Wide/120-Volt LAUNDRY CENTER Owner's Manual And Installation Instructions page 17

B. INSTALL LEVELING LEGS
To install rear legs:
STEP 1. If you have not already done
so, lay the laundry center on its side.
Because of the weight of the laundry
center, two people should lay it down.
STEP 2. Push legs into holes in rear
corners until they snap into place.
STEP 3. Check adjustability of rear
legs. by pushing in one leg. The other
leg should come out. Check both legs.
If they do not adjust, repeat STEP 2.
To install front legs:
STEP 1. Screw front legs into the holes
in the triangular braces in front corners.
Screw them in with an adjustable wrench
to the diamond marks on the ridges.
i______
m
STEP 2. Carefully stand the: laundry
center upright. Because of the weight
of the laundry center, two people
should lift it.
C. REMOVE STYROFOAM
PACKING
To prevent floor damage, set laundry
center onto cardboard before moving
across floor.
Move laundry center close to its final
location.
STEP 1. Open the washer lid. The latch
under the dryer will keep the lid open.
Read, then remove the yellow card on
the agitator.
Yellowcard
STEP 2. Pull the styrofoam packing out
of the washer.
17
i