GE Monogram ZGU48N4G Owner's Manual page 13

k
Using Your Coo top
Stainless Steel Cookto D
Electronic
ignition &
automatic
reignition
X_)ur surtace burners are equii)ped with
electronic ignition which diminates the
need tot a standing pilot light.
_M1igniters will spark and make clicking sotmds
when only one burner is being turned on.
Do not touch any of tile btu'neI_ when igniteI_
are clicking.
Tile bm'ners on this cooktop will automatically
relight if the flame goes out. _M1burnei_ will
spark while any one bm'ner is relighting.
Btu'ners may spark if wind or a drati litis tile
flaIIle }lIV}lV li'oI// tile flaII/e seilsoi'.
In case of a power outage, you can light tile
S/lI{_lce buI'IleI3 oil vo/iY
cooktop
with
a illatch.
Hold a lighted match to tile
btu'IleI;
then ttlFIl
the knob to the HIGH position. Use exlreme
caution when lighting burners this way.
Push tile control knob down and mrn it
com_terdockwise to tile I,ITE position.
After the burner ignites, turn tile knob in either
direction to a(!just the flame size.
To turn a burner off, tm'n tile knob clockwise,
as tin" as it will go, to tile OFF position.
• All of tile bm'ners can be used ti)r both
general cooking and simmering.
• Do not operate a burner for an extended
period of time without cookware on tile
grate. The finish on the grate may chip
without cookware to absorb tile heat.
• For yotu" convenience, tile indicator lamp
in the bezel ti)r each knob verifies the
b/irller is
"ON".
• Be sm'e w)u tm'n tile control knob to "OFF"
when you finish cooking.
Ho_l)
to select
flame size
_'_tcl/ tile flame, not tile knob, as w)u increase or
reduce heat.
Tile flame size on a gas bm'ner should match tile
cookware
}'Oil are using.
FOR S_d_E HANDI.ING OF COOKX4;M_.E,
NEVER I,ET THE FIAME EXTEND UP THE
SIDES OF THE COOf4A4;M?.E.Any flame larger
than tile bottom of tile cookware is wasted and
only serves to heat the handle.
NOTE: Use 10" or larger dianleter
cookware when using heat settings between
HI and X-HI.
13