GE Monogram ZGU375LS Owner's Manual page 15

Burner cads
Do not use a steel wool pad; it will scratch
the surface.
I,ilt off when cool. X4'ash burner caps in hot, soapy
water and rinse with clean watei: You inav scour
with a plastic scotwing pad to remove bm'ned-on
tood pmticles.
D_y them in a wam_ oven or with a cloth--don't
reassemble them wet. Replace the btmaer caps.
Make sm'e that caps are replaced on the correct
size burnei: There ale tour inediuln sets and one
large set of rings, heads and caps.
LargeCap
Medium Medium
Cap Cap
Medium Medium
Cap Cap
00%
Front o fCooktop
Cast-iron bm'ner grates should be washed
regularly and especially atter spillovers.
_'Xash them ill hot, soapy water and rinse
with clean water. Dry the grates with a cloth--
don't put them back on the cooktop wet.
When replacing the grates, be sure they're
positioned securely over tile burners.
To get rid of burned-on food, place the
grates in a covered container or plastic bag.
Add l/4 cup ammonia and let them soak
for 30 minutes. Wash,
rinse well and dry.
Tile grates may also be cleaned in a dishwasher.
Although they awe durable, the grates will
gradually lose their shine, regardless of the
best care you can give them. This is due to
their continual exposure to high temperatm'es.
Do not operate a burner for an extended
period of time without cookware on the grate.
Tile finish on tile grate may chip without
cookware to absorb the heat.
After cleaning, replace tile two side grates with
their locking rails toward the center. Replace
tile center grate so that a COlltintlO/lS "arc" is
formed with the center ribs of all three grates.
Make sure the rails on the center grate are
locked over the rails on tile side grates and that
all grates are stable and level.
Rubber Grate Feet
For stabilit> your cooktop has two rubber _bet
on each leg of tile bm'ner grates. If ally of these
rubber _bet shoukl become damaged or lost,
replace it with one of the extra rubber feet
supplied with your cooktop.
Arc
Arc
15