Table of Contents
Advertisement
5.
Check the "ACTIVE" LED: if power is successfully fed into the IWE3200-H, the "ACTIVE"
LED will be on (Red light); otherwise, the "ACTIVE" LED will be off.
6.
If the electricity current is over the normal condition (Io＞1.0 A), the "ACTIVE" LED will flash
(Red light).
IWE500-INJ is specially designed for IWE3200-H. The use of IWE500-INJ with other
Ethernet-ready devices that are not compliant to IEEE 802.3af may cause damage to the
NOTE:
devices.
2.2. Mounting the IWE3200-H on a Wall
The IWE3200-H is wall-mountable.
1.
Stick the supplied sticker for wall-mounting.
Use a φ 6.5mm driller to drill a 25mm-deep hole at each of the cross marks.
2.
3.
Plug in a supplied plastic conical anchor in each hole.
4.
Screw a supplied screw in each plastic conical anchor for a proper depth so that the IWE3200-H
can be hung on the screws.
5.
Hang the IWE3200-H on the screws.
Fig. 4. Connecting Ethernet cables to IWE500-INJ.
Fig. 5. Mounting the IWE3200-H on a wall.
9
Advertisement
Table of Contents
