Configuring Radius Settings - Ovislink IWE3200-H User Manual

defined Fig 24 of Sec.2.4.7.2.
2.4.6.4. IEEE 802.1x
Fig. 23. Changing security mode to an IEEE 802.1x option.
To setup IEEE 802.1x-based user authentication, go to WIRELESS Communication Security
section, and then change the Security mode setting to an IEEE 802.1x-related option according to
your needs. The advanced wireless access Router supports IEEE 802.1x EAP-MD5, EAP-TLS,
EAP-TTLS, PEAP, and WAP authentication methods. Click Save when finished.

2.4.7. Configuring RADIUS Settings

The RADIUS client on the IWE3200-H works in conjunction with the Web redirection component
and IEEE 802.1x component for wireless user authentication. The Web redirection and IEEE 802.1x
components are responsible for acquiring user credential information, and the RADIUS client com-
municates with a back end RADIUS server using the user credential information.
Go to the AAA RADIUS section, and then configure the RADIUS settings. You have to configure
at least Authentication method, Primary RADIUS server, Shared key, and Identifier of this NAS
settings. And leave other settings to their default values. Click Save & Restart when finished.
The RADIUS server do not support all combinations of authentication methods if both
IEEE 802.1x and Web redirection are enabled. The following table shows the allowable
IEEE 802.1x and Web redirection authentication modes.
NOTE:
Fig. 24. RADIUS settings.
IEEE 802.1x
Disabled
20
IEEE 802.1x IEEE 802.1x
EAP-MD5 EAP-TLS