Table of Contents
Advertisement
Recording
Recording to a Tape Player
Input signals from an audio source playing in the DMC-1 can be recorded using the left and right
audio outputs. The tape player will receive a straight copy of the analog source signal going in,
unaffected by the volume, tone, or any surround modes. If you are playing a digital source, the tape
player will receive a down mixed stereo analog signal for recording.
• Select the source (such as CD) and play it through your system.
• Set your tape player to record and adjust the input levels for the best performance. Once the levels are
correct, you can reset your source to the beginning and make your recording.
• Do not select another Main Zone input while you are recording.
1
3
2
4
Connect "PLAY" from
1
DMC-1 to Tape INPUTS
Connect "RECORD" from
2
DMC-1 to Tape OUTPUTS
Connect "PLAY" from
Connect "RECORD" from
3
4
DMC-1 to Tape INPUTS
DMC-1 to Tape OUTPUTS
Recording to a VCR
Any video source playing in the DMC-1 can be
recorded using the left and right audio and the video outputs. The VCR will receive a straight copy
of the source signal going in, unaffected by the volume, tone or any surround modes.
• Select the video source and play it through your system.
• Set your VCR to record.
• Do not select another Main Zone source while you are recording.
• The VID2/MON2 output can also be used for recording, but first make sure that it is set to VID2 in the
VIDEO menu of the OSD (see page 61). This output will then mute to prevent feedback whenever the VID2
input source is selected.
• Do not use the OSD while recording as the incoming video is shut off while the OSD is displayed
Page 69
Advertisement
Table of Contents
