Programming And Configuring Your Components; P-Pro - Emotiva DMC-1 User Manual

Programming and Configuring YOUR Components

You must enter the SETUP mode to program the remote control for the other components in your
MAIN Button
Press MAIN and ENT
buttons simultaneously
for 3 seconds to enter
the SETUP mode
ENT Button

P-PRO

The remote is pre-programmed to operate many types of equipment. The P-PRO mode allows you
to enter a 3-digit code to recall the commands for each of your system components.
1) Find the brand of your TV, DVD, VCR, CD and other components, then look at the tables at the back
of this manual. Make a note of the various codes for each piece. Note that some TV/VCR combined
units may use VCR codes, not TV codes.
2) Sit in a position in front of your equipment, and make sure that all components are turned off.
3) In the SETUP mode, press P-PRO and the device labels will appear.
4) Select the device button you wish to program, then choose the device table you took the code
from. For example, for a TV, press TV twice. If you want AUX to control a VCR, press AUX, then press
VCR.
5) You can now enter a code using the remote's keypad, or UP or DOWN. After the third digit is
entered, the remote transmits a power command. If the component turns on, press SAVE and then
EXIT.
6) If you could not find a code which works, hold the UP button to step through all the codes in the
table for that device. Release UP when your equipment turns on. If you go past, press DOWN. Press
SAVE and then EXIT.
7) The display will change to show the devices again, still in the P-PRO mode. Repeat steps 4 to 7
until all your equipment is working.
8) Press MAIN to return to the main menu from any setup mode.
system, and to customize it for your convenience. There is
only one way to enter the SETUP mode: Hold down both
the MAIN and ENT buttons for a few seconds until SETUP
appears in the display.
Each of these setup options is described in the subsequent
pages of this section. Please note that there are multiple
steps involved in each program sequence, so it is best to
read through the section thoroughly BEFORE beginning to
setup the DMC-1 remote.
The SETUP display shows 10 options.
P-PRO LEARN
FAV MACRO
PUNCH RECAL
ERASE EDIT
LIGHT CLONE
Page 44