Connecting A Cassette Tape Or Dat Deck - Emotiva DMC-1 User Manual

Connecting a Cassette Tape or DAT Deck

This configuration shows a Cassette Tape Deck connection where the audio output is taken from the
left and right audio outputs (may also be labeled PLAY). If you plan to use the Cassette Tape Deck
for recording, you also must connect the DMC-1's TAPE audio outputs into the Cassette Tape Deck
inputs (may also be labeled RECORD).
1
2
1
The Tape Deck outputs are
sometimes labeled PLAY
2
The Tape Deck inputs are
sometimes labeled RECORD
Depending on the type of tape deck you connect, the inputs and outputs on the DMC-1 can be
connected to TAPE or DAT. If you have both types connected, the DMC-1 will switch automatically on
to whichever source is playing. You can't have both playing at the same time. In the diagram shown,
recording from any selected source is possible except recording between Cassette Tape and DAT. This
is called "dubbing" and is beyond the design intent of the Emotiva DMC-1 preamplifier/processor.
Page 31