GE Model 18 Owner's Manual And Installation Instructions page 15

Installation Instructions
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT (For
freezer swing door models only)
Pull tile base grille straigbt out to gain access to tile
hinge bracket screws.
Using a 5/16" socket wrench, remove tile hinge
bracket, screws, plastic washer and spacer shim from
tile bottom right side of"the cabinet.
Reinstall tile spacer shim, hinge bracket, screws and
plastic ,a_asher to the bottom left side of tile cabinet.
Remove the cap from tile left end of the base grille.
Install tile cap, supplied inside the kit, on tile right
end of the base grille. Reinstall the base grille and
push it firmly into place.
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove tbe center hinge bracket and shim by
removing tbe tbree screws. NOTE: Keep these screws
with tim hinge bracket. They are longer screws and will
be used when installing tim hinge on tbe other side.
f
Remove the tbree painted screws and take vcashers
from the center left side of tbe cabinet. Screw them
into tbe holes on the rigbt side, which were uncovered
above.
Place tbe center hinge bracket and shim over the holes
at tbe center left side of tbe cabinet. Insert the three
screws tbat were removed with the center hinge bracket
at tbe beginning of" Step 4 and tighten securely.
_'gr£
Do not install tbe hinge pin yet.
[] TRANSFER TOP HINGE
TO THE LEFT
Interchange hinge and shim at top right with two
plug buttons at top left of cabinet. Do not tighten
screws on hinge side at this time.
15