GE Model 18 Owner's Manual And Installation Instructions page 16

Installation Instructions
REVERSING THE DOOR SWING (CONT.)
[] TRANSFER DOOR STOPS
On each door, remove the metal door stop. Use tile
center hinge pin as a guMe to align tile door stop,
supplied inside tile kit, on tile opposite side, after
reversing tile handles.
On freezer drawer models, only dm refiigerator door
has a door stop.
[] PREPARE FREEZER HANDLE
FOR DOOR SWING CHANGE (For
freezer swing door models only)
One of the illustrations below will look like your
freezer door handle.
Remove the four handle mounting screws. Remove
the plug button and plug button retainer and transfer
them to the opposite side. Reinstall handle.
_ [..,._ Handle
Plugbutton _ screwsm°Unting
Plugbutton_
retainer
Remove tile plug button and transfer it to tim
opposite side.
Plugbutton
__
NOTE: Make sure tile door stop on tile bottom oftbe
door has been transferred to tile left side of the door
as explained in step 6.
[] TRANSFER REFRIGERATOR
DOOR HANDLE TO THE RIGHT
Remove tbe four handle mounting screws. On some
models, you must first remove the screw covers.
Using a putty knife, remove tbe tour screw hole plug
buttons from the right side of tbe door.
Reinstall tbe plug buttons on dm left side of tbe door:
Align the handle over tbe holes in tbe right side of
tbe door and install the four mounting screws and
screw covers (on some models).
At tbe top of the door, remove the plug button using
a putty knife and reinstall it in tbe top right hand
side hole.
One of the illustrations bdow will look like your
refrigerator door handle.
Hondle :,--P, ogb tteo
Handle
mounting
SCreWS
Handle
door
e.dlt.r-Plug button
NOTE: Make sure the door stop on the bottom of
tbe door has been n'ansferred to tbe lett side of the
door as explained in step 6.
16