GE JGB920 Owner's Manual And Installation Instructions page 51

Read these instructions completely and carefully.
[] Installing the Anti-Tip Device
WARNING:
Range must be secured with an approved
Anti-Tip device.
Unless properly installed, the range couM be
tipped by you or a child stan(fing, sitting or
leaning on an open door.
After installing the Anti-Tip dexdce, veri6, that
it is in pla(e by (arefiflly attempting to tilt the
range fi)m_ud.
This range has been designed to meet all
recognized indusuy tip stan(knds for all
noiillal (onditions.
The use of this device does not preclude
tipping of the range when not properly
installed.
_, If the Anti-Tip device supplied with the range
does not fit this appli(ation, use tim universal
Anti-Tip device WB02X7909.
[]
Mark tile wall where tim RIGHTEDGEof the
range is to be lo(ated. Be sure to allow fi)r the
( ountertop overhang if you intend to install
the range next to cabinets.
_ devAnti-Tip l
ice t
Slottedheadscrew _-::._L,[j ' P "_
_I-_l wallplate I
L
/7 2'A" /" Marked edge o frange
[] Locate tim outside edge of tim device 2¼"
toward the (enter of the range fiom the
marked edge of the range.
[] Using the device as a template, mark the
position of the hole ti)r the screw.
[] For wood consuuction, drill a pilot hole at an
angle of 20 degrees fiom the horizontal. A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device xdth the screw proxfded.
For cement or concrete
constI'tlction, you
will need a 1/4" x 1_//'lag bolt and a 1/2" O.D.
sleeve anchor, whicll are not prox4ded. Drill
the recommended size hole for the hardware.
Wallboard
Back of range
Anti-_p
device
Install tim sleeve anchor into tim &illed hole and
then install the lag bolt flnough tim dex4(e. The
bolts nmst be properly tightened as re(ommended
fin"the hardware.
[] Slide the range against the wall, and check fi)r
proper inslallation by grasping the fiont edge
of the cooktop and cmefiflly atmmpting to tilt
the range fi)_wmd.
When All Hookups Are Completed'.
MAKESURE ALLCONTROLS A RELEFT IN THEOFF
POSITION.
MAKESURETHE FLOWOFCOMBUSTION AND
VENTILATION A IR TOTHE RANGEIS UNOBSTRUCTED.
Cofivertifi# to LP _aS (or converting back to natura/ gas from LP)
Thisrangeleaves thefactory set forusewith natural g as.
If youwant toconvertto LP gas,theconversion m ustbe
performed bya qualifiedLP gasinstaller
)
The conversion instructions, sticker and I,l orifices
can be found attached to the range next to the
pressure regulator.
There is a second set of insu_ucfions included in the
envelope contzdning the pro&_ct wMng diagrams
on the back of the range. Keep these instmcdons
and the orifices in case you want to convert back to
natural gas.
5/