GE Monogram ZEU36K Owner's Manual page 13

Using
the bric(ge
S !l I.'/( l Ce
element
The surtace element on the right side of w)ur
cooktop is designed to let w)u heat all parts
of a large, oblong utensil that is too large to
fit on one surt,_ce elen_ent. The Bridge Surtace
Elen_ent is inade up of a fl'ont section, a middle
section, and a rear section. You can heat all
sections at once, or the ti'ont and rear
sections sel)aratelv.
Push down and turn the right rear surfllce
elen_ent control knob clockwise to _ and select
your desired setting. This will allow you to heat
the right rear and middle sections of the Bridge
Surihce Elen/ent. To use the entire bridge
elen/ent, also push down and turn the right
fl'ont suriace elelnent control knob to the
desired setting.
Choose pans that match the heated area as
closely as possible.
To use only the right rear surihce elen_ent
without the iniddle section, push down and
turn the right rear surihce elen_ent control
knob counteI_clockwise to _ and select
yore" desired setting.
Lrse the right front control knob to heat
the right fl'ont section of the Bridge Surthce
Elenmnt.
OFF
Right rear ,_// _ Right rear
surface [[ _ and bridge
element._,- _,ll IJ,._-_ surface
settings \\
/]
element
.\ eet, nge
LO LO
Using
the tri-ring
S_lrf (lce
element
The center 7)'i-Hing" su{/hce element ha,s 3 size,_ to
se&ct /mm so you _an match the size o/the e#ment
to the size o/ the cookware you are using"
To use the lalge surthce elemelat, push
and turn the center control knob clockwise
to @, stopping at the desired setting. This
will activate the entire heating area.
To use the medimn surthce element, press
and turn the center control knob clockwise
to @, stoi_i_ing at the desired setting. This
will activate the mediun>size heating area.
To use the smallest surfilce element, press
and turn the center control knob clockwise
to @ , stoi)ping at the desired setting. This
will actiw_te the smallest, inside heating area.
OFF
Small
/" ÷_o _X
Large
surface /_.// %_@.. surface
element._,-@
1[
/_ ((@j_._-_element
setting /_\ ]]_T setting
\ _'_.
//_ /
Medium \\
surface '_"_
element "_-_/
setting
13