Advertisement
Available languages
Available languages
=
Steedng Wheel
Insert
Steering
Boot
Steedng
Wheel
(1) 5t16-18
x 4
Hex Bolt
(1) Lockwasher
Steedng
j_
@
Shaft Cover
Steedng
Shaft
Stee_ng
Wheel
(1) Large Flat
Extension
Adapter
Washer
(1) Cup Washer
Seat
(I) Knob
I
(t) Rear Bumper
(1) Front
Bumper
(4)Screw
#10 x 0,200
(1) Shroud
(2)Key
Slope Sheet
Your new riding mower has been assembled at the factorywith the exception ofthose parts
left unassembled for shipping purposes. To ensure safe and proper operation of your riding
mower all parts and hardware you assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier.
Standard wrench sizes you need
are listed below.
(1) 1/2" wrench
(1) Utility knife
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means when you are in the
operating position (seated behind the steer-
ing wheel).
TO REMOVE RIDING MOWER FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts and
parts boxes from carton.
2. Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
3. Remove packing materials from riding
mower.
4. Check for any additional loose parts or
cartons and remove.
NOTE: Only cut carton with a short blade
utility knife, a long blade or saw can puncture
tires on unit.
HOW TO SET UP YOUR RIDING
MOWER
CHECK BA'I-rERY
Ensure battery is securelyfastened, andthat
all wiresare securely connected,
°
Battery is located under the seat,
•
Battery has been fully charged from the
factory, before installation.
Seat
artery
7
Advertisement
