Epson UB-E02 Technical Reference Manual page 80

5.5.5.2 Internal Parameter Setting Methods
1. Using the exclusive utility.
2. Using a browser
3. Using arp and ping commands (only to set IP address)
5.5.5.3 Setting with Exclusive utility
Settings cannot be made by the specified application software when the ENPC protocol is used.
A dedicated utility which can set miscellaneous with the ENPC protocol is provided by EPSON.
5.5.5.4 Setting with Browser
Setting can be made by an HTTP browser when connected to the module. The new IP address
takes effect when the printer power is turned off and back on.
5.5.5.5 Setting the IP Address with arp + ping
This function is available when it has been enabled.
The setting can be made from a host in the same segment as the module.
The host must support both arp and ping commands.
The new IP address takes effect when the module responds to the ping command.
Example-1: using SunOS
Example-2: using Windows
5.5.5.6 How to check the Mac Address
The Mac address of the UB-E02 can be checked with any of the following methods:
Printing the status sheet
Checking the label on the UB-E02
Checking the HTTP browser
Checking the printer self-test (however, the self-test function is limited for each model.)
5-8 Specifications
arp -s 123.456.789.123 00:00:48:06:00:01 temp
ping 123.456.789.123
arp -s 123.456.789.123 00-00-48-06-00-01
ping 123.456.789.123
Rev. A