Ub-E02 Installation - Epson UB-E02 Technical Reference Manual

2.5 UB-E02 Installation

CAUTION:
Before installing the UB-E02, be sure to set the DIP switches or Memory switches as shown
in the table below. For other models, please ask your dealer.
Model
TM-U200 Series
TM-U210 Series
TM-U220 Series (STD) *1
TM-U220 Series (US) *1
TM-U230 Series
TM-U325 Series
TM-U590 Series
TM-U675 Series
TM-T88/T88II/T88III
TM-T90
TM-H5000/H5000II
TM-H6000/H6000II
TM-J7000/J7100
TM-J7500/J7600
TM-J2000/J2100
TM-L90
*1 TM-U220 has two DIP switch pattern. See TM-U220 Technical Reference Guide for detail.
Be sure to disconnect the power supply of the printer (in addition to turning off the power
switch) .Even when the power switch is turned off, some of the internal circuit board has
electricity. If you install or remove the UB-E02 with the power supply connected, the UB-E02
and the printer may be damaged.
1. Be sure that the power for the printer and host computer is turned off.
2. Install the UB-E02 in the printer.
If an interface circuit board is already installed, remove it and install the UB-E02.
Rev. A
Setting
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW2-8: ON
DIP SW2-4: ON
DIP SW 2-4: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 1-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 1-8: ON
MSW 1-8: ON
MSW 1-8: ON
MSW 1-8: ON
UB-E02 Technical Reference Guide
Installation 2-3