Canon MF3240 - ImageCLASS B/W Laser Software Manual page 193

Introduction
1
Printing
2
Scanning a
Document
3
PC Faxing
4
Troubleshooting
5
Appendix
6
Table of Contents
Index
1.
Select the object whose display order you
want to change.
NOTE
– You can select multiple objects and change the order of display
for all of them at the same time.
– If the object you want to select lies behind other objects and
thus is hidden from view, press [TAB] on the keyboard
repeatedly until the object you want is selected. You can also
select in reverse order by holding down [SHIFT] on the
keyboard while pressing [TAB] on the keyboard.
2.
Click [ ] (Bring to Front), [
Back), [ ] (Bring Forward), or [
Backward) on the toolbar.
NOTE
Alternatively, select [Bring to Front], [Send to Back], [Bring
Forward], or [Send Backward] from the [Layout] menu.
● Aligning Multiple Objects
You can align multiple selected objects according to their left
edge, right edge, top edge, bottom edge, or center in one
operation. The position of the last selected object becomes the
point of reference of alignment.
Use the following commands to change the alignment of the
selected objects.
– [Align Left]: Aligns the left edge of all objects along the left
edge of the last selected object.
– [Align Center]: Aligns the left-right center axis of all objects
] (Send to
along the left-right center axis of the last selected object.
] (Send
– [Align Right]: Aligns the right edge of all objects along the
right edge of the last selected object.
– [Align Top]: Aligns the top edge of all objects along the top
edge of the last selected object.
– [Align Middle]: Aligns the top-bottom center axis of all objects
along the top-bottom center axis of the last selected object.
– [Align Bottom]: Aligns the bottom edge of all objects along the
bottom edge of the last selected object.
TOP
Back Previous Next
4-65