Onboard Headers And Connectors - ASROCK N68-VGS3 FX Quick Installation Manual

after you update the BIOS. If you need to clear the CMOS when you just finish
updating the BIOS, you must boot up the system first, and then shut it down
before you do the clear-CMOS action.

2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 6)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (PORT 0.0):
see p.2, No. 12)
(SATAII_2 (PORT 0.1):
see p.2, No. 9)
(SATAII_3 (PORT 1.0):
see p.2, No. 11)
(SATAII_4 (PORT 1.1):
see p.2, No. 10)
Serial ATA (SATA)
Data Cable
(Optional)
ASRock N68-VGS3 FX / N68-VS3 FX
80-conductor ATA 66/100/133 cable
These four Serial ATAII (SATAII)
connectors support SATAII
or SATA hard disk for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
connect the black end
to the IDE devices
Motherboard
1 7 1 7 1 7
1 7 1 7