Asus P5QC - Motherboard - ATX User Manual page 54

4. ICH10R Serial ATA connectors [red] (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives and optical disc drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5,
and 10 configuration with the Intel
onboard Intel
•
•
•
•
Connect the right-angle side of SATA
signal cable to SATA device. Or you may
connect the right-angle side of SATA
cable to the onboard SATA port to avoid
mechanical conflict with huge graphics
cards.
2-28
®
ICH10R RAID controller.
These connectors are set to Standard IDE mode by default. In Standard
IDE mode, you can connect Serial ATA boot/data hard disk drives to these
connectors. If you intend to create a Serial ATA RAID set using these
connectors, set the Configure SATA as item in the BIOS to [RAID]. See
section 3.3.6 Storage Configuration for details.
Before creating a RAID set, refer to section 4.4.3 Intel RAID
configurations or the manual bundled in the motherboard support DVD.
You must install the Windows
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is
available only if you are using Windows
When using hot-plug and NCQ, set the Configure SATA as in the BIOS to
[AHCI]. See section 3.3.6 Storage Configuration for details.
®
Matrix Storage Technology through the
XP Service Pack 1 before using Serial ATA
®
XP or later version.
®
right angle side
Chapter 2: Hardware information