Deleting (Or Adding) Channel(S) - Emerson EWC20D5 A Owner's Manual

DELETING (OR ADDING)
CHANNEL(S)
The channels you no longer receive or seldom watch
can be deleted from the memory. (Of course, you can
add the deleted channel into the memory again.)
1
Select "CHANNEL SET UP"
Hit [SETUP] on the remote control.
Press [K K /L L ] to point to "CHAN-
NEL SET UP".
Then hit [ENTER].
2
Select "ADD/DELETE CH"
Press [K K /L L ] to point to
"ADD/DELETE CH".
Hit [ENTER].
3
Enter the desired channel number
Press [K K /L L ] until your desired
channel number appears. (You can
also press the number buttons or
[CH. K K /L L ] to enter it)
(Example: CH8)
•
You must precede single-digit
channel numbers with a zero (Example: 02 ... 09).
•
When selecting cable channels which are higher
than 99, hit +100 first, then hit the last two digits.
(Example: to select channel 125, first hit +100,
then press 2 and 5).
4
Delete (or add) it from (or into) memory
Hit [ENTER]. The channel number changes to light
red. The channel is deleted from memory.
•
To delete another channel, repeat steps [3] to [4].
•
If you hit [ENTER] again, the channel is memo-
rized again.
Added channel: Light blue
Deleted channel: Light red
5
Exit the channel setup mode
Hit [SETUP] to return to TV mode.
NOTE: To confirm that channel(s) has been deleted
or added, press [CH. K K /L L ].
TV
- TV SETUP -
B CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
– CHANNEL SET UP –
B ADD / DELETE CH (CATV)
AUTO CH PROGRAMMING
08
ADD / DELETE
– 14 –
EN