Mpaa Rating Set Up - Emerson EWC20D5 A Owner's Manual

B

MPAA RATING SET UP

Follow steps 1 to 3 in the "V-CHIP SET UP" section
on page 17.
4
Select your desired item
Press [K / L] to point to your
desired item, then hit [ENTER] to
select [BLOCK] or [VIEW].
Selection Rating Category Explanations
G General Audience
PG Parental Guidance suggested.
PG-13 Unsuitable for children under 13
R Restricted; under 17 requires accompa-
nying parent or adult guardian
NC-17 No one under 17 admitted
X Mature audience only
•
When you select a rating and set it to [BLOCK],
the higher ratings will be blocked automatically.
The lower ratings will be available for viewing.
•
When you set the lowest rating to [VIEW], all
other ratings will automatically be available for
viewing.
5
Exit the V-Chip setting mode
Hit [SETUP] to exit the menu.
C
Follow steps 1 to 3 in the "V-CHIP SET UP" sec-
tion on page 17.
Press the Number buttons to
G [VIEW]
PG [VIEW]
PG–13 [VIEW]
enter your desired access code in
B R [BLOCK]
NC–17 [BLOCK]
the "NEW CODE" space, then
X [BLOCK]
enter the same code in the "CON-
FIRM CODE" space. When com-
pleted, the menu will return to "V-CHIP SET UP".
•
Hit [SETUP] to exit the menu.
NOTE:
•
– 18 –
CHANGE ACCESS CODE
4
Enter New code
Make sure you enter exactly the same new code in
the "CONFIRM CODE" space as one in the
"NEW CODE" space. If they are different, the
"NEW CODE" space is cleared for redoing.
5
Exit the V-Chip setting mode
Your personal access code will be erased and will
return to the default (0000) when a power failure
occurs or when you turn off the power using a
wall switch. If you have forgotten the code, unplug
the power cord for 10 seconds to restore the access
code to 0000.
NEW CODE
_ _ _ _
CONFIRM CODE
_ _ _ _
EN