Sleep Timer; Switching Each Input Mode; Channel Selection; Still Mode - Emerson LD320EM2 Owner's Manual

14
WATCHING TV

Sleep Timer

can set the unit to go into standby mode after an incremental period of time.
Press SLEEP repeatedly to change the amount of time (increases
the time by 30 minutes up to 120 minutes).
Press SLEEP once to call up the display for checking the remaining time.
• To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is
displayed.

Switching Each Input Mode

between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press INPUT SELECT or CH ▲ repeatedly to cycle through the input modes.
e.g.) LD320EM2/LD260EM2
Input Select
TV
TV
Video
HDMI1
Component
HDMI2
HDMI1
DTV / TV channel
Component
HDMI2
Video
• Pressing CH ▼ reverses the direction of the input modes.
These may differ depending on what product you purchased. For example,
*
LD190EM2 will be displayed [HDMI1], [HDMI2] and [PC] instead.

Channel Selection

Select channels by using CH ▲/▼ or the Number buttons.
• To select the memorized channels,
use CH ▲/▼ or the Number buttons.
• To select the non-memorized channels,
use the Number buttons.
To use the Number buttons
ATSC
- When selecting digital channel 11−1
Be sure to press − before entering the subchannel number.
NTSC
- When selecting cable or analog channel 11
Press CH RETURN to return to the previously viewed channel.
Note
• [No Signal] will appear on the TV screen after the subchannel
broadcast is over.
• [Audio only program] message will appear on the TV screen, when you
receive only sound signal.

Still Mode

can freeze the image shown on the TV screen for 5 minutes.
Press PAUSE F to freeze the image.
Still
• The sound output will not be paused.
• To cancel freeze mode, press any buttons except POWER.
can easily switch with the remote control
Video Component
11-1
HDMI2
(or PC input)
Sleep 120min.
HDMI1
11-1