Installation Instructions - Electrolux EKG6046 User Manual

Installation instructions

Important safety requirements
Warning! This appliance is not
suitable for installation in flats or
other mutli occupancy dwellings as
defined in clause 8.2.1 of IGE/G/5.
Where applicable Natural Gas and L.P Gas
versions of this appliance are available.
Check that this model is suitable for the type
of supply available.
This appliance must be installed and/or serv-
iced by a competent person, in accordance
with the Gas Safety (Installation and Use)
Regulations Current Editions and the IEE
Wiring Regulations.
Detailed recommendations are contained in
the following British Standards Codes of
Practice - BS.5440: Par 2 and BS.6891. All
British Standards must be 'Current Editions'.
Warning! This appliance must be
installed by a qualified electrician /
competent person (Gas Safe Register
registered). Safety may be impaired if
installation is not carried out in
accordance with these instructions.
Before connecting the appliance make
sure that the voltage of your electricity
supply is the same as that indicated on
the rating plate. This is situated on the
lower front frame of the appliance and
can be seen upon opening the door.
Alternatively the rating plate may also be
found on the back or top of some mod-
els (where applicable).
Do not alter the electrical circuitry of this
appliance.
Provision for ventilation
This appliance is not connected to a com-
bustion products evacuation device. It shall
be installed and connected in accordance
with the current installation regulations.
Particular attention shall be given to the rel-
evant requirements regarding ventilation.
The room containing the appliance should
have an air supply in accordance with BS.
5440: Part 2 Current Edition.
All rooms require an openable window or
equivalent and some rooms will require a
permanent vent as well.
For room volumes up to 5m
2
100cm is required: for room volumes be-
3
tween 5m and 10m
required.
If the room has a door that opens directly to
the outside, no air vent is required.
For room volumes that exceed 11m
vent is required.
If there are other fuel burning appliances in
the same room, BS.5440: Part 2 Current Ed-
ition should be consulted to determine the
requisite air vent requirements.
Prolonged intensive use of the appliance may
call for additional ventilation, for example
opening a window, or more effective ventila-
tion, for example increasing the level of me-
chanical ventilation where present.
Moving the appliance
You may damage some soft or badly fitted
floor coverings when you move the appli-
ance.
The floor covering under the appliance
should be securely fixed so it does not ruck
up when you move the appliance across it.
Alternatively you could remove the floor cov-
ering.
This appliance is heavy and care must be
taken when moving it.
Do not try to move the appliance by pulling
the door handles.
To move the appliance open the grill door.
Raise the appliance off its front feet by lifting
it from inside the oven. Pull the appliance for-
ward.
When you replace the appliance push it back
to the stop and make sure there is the same
gap at each rear corner.
For your safety
Do not try to disconnect the appliance from
the gas supply if the supply pipe does not
have a bayonet connection, as described in
the installation instructions. If this is the case
contact the person who installed the appli-
ance.
Location of the appliance
This appliance must not be installed in a bed-
sitting room of volume less than 20m
bathroom, shower room or garage.
electrolux 21
3
an air vent of
3
an air vent of 50cm
3
no air
3
or in a
2
is