Starting Warm Engine; Stopping Engine - Echo SRM-225i Operator's Manual

startIng warm engIne

The starting procedure is the same as Cold Start except DO NOT close
the choke, and do not hold throttle trigger fully depressed.
WARNING
The attachment should not move at idle, otherwise serious per-
sonal injury may result.
NOTE
If attachment moves, readjust carburetor according to "Carburetor
Adjustment" instructions in this manual or see your ECHO Dealer.
Stop Switch
1.
Move stop switch button (A) forward away from the STOP posi-
tion.
Purge Bulb
2.
Pump purge bulb (C) until fuel is visible in the "Clear" fuel return
line.
NOTE
Energy is stored in the starter spring each time the handle/rope is
pulled. Generally two to six pulls, using light pulling forces, will
store enough energy to engage the starter and spin the engine. Do
not pull the rope out to end stop.
3. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts
clear of all obstacles. Gently pull the recoil starter handle (D) until
engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.

stoppIng engIne

Release Throttle.
1.
Allow engine to return to idle before shutting off engine.
Stop Switch
2.
Move stop switch button (A) backward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP posi-
tion, close choke - COLD START position - to stall engine. Have
your ECHO dealer repair stop switch before using trimmer again.
G T
rass rimmer
O
peraTOr
C
D
/B C
rush uTTer
' m
s anual
A
A
17